A useful first CAD exercise is a small plate with a hole. It introduces the same habits you will use in larger drawings: choosing a coordinate convention, entering dimensions, checking geometry, and saving a file you can reopen.
For this exercise, use a plate that is 120 units wide and 80 units high, with a 10-unit-radius circle at its center. Treat one drawing unit as one millimeter for the exercise, and record that convention when you share the file. Typing a number alone does not explain its physical unit to someone receiving the drawing.
Start with a clean drawing
Open the RLabCAD editor and choose New File. If another drawing is open, export a backup first. A new file gives you a clear place to practice without mixing the exercise with existing work.
Use the mouse wheel to zoom and the middle mouse button to pan. These change your view of the drawing; they do not resize the geometry.
Draw the plate outline
Start the Rectangle command from the toolbar or command terminal. Follow the prompt at the bottom of the editor:
- Enter
0,0for the first corner and press Enter. - Enter
120,80for the opposite corner and confirm. - Use Fit if the new outline is outside your current view.
The rectangle is stored as a closed polyline. You can select and edit it later, but moving an individual corner can also change it into a shape that is no longer rectangular. For a first exercise, keep the original outline intact.
Add the center hole
Start the Circle command. Enter 60,40 for its center, then enter 10 for the radius. The center is halfway across each side of the plate: 120 divided by two is 60, and 80 divided by two is 40.
Watch the command prompt as you work. A value entered at the wrong step can mean a coordinate rather than a radius. Press Escape to cancel an unfinished command and start again if the prompt no longer matches what you intended.
Check the result
Do not judge the plate’s size from its appearance on screen. Zoom can make a small object look large.
Use Distance to check an edge between its endpoints. The horizontal side should measure 120 and the vertical side 80. Select the circle and inspect its properties to confirm the radius is 10. Its diameter is therefore 20.
If a measurement is wrong, correct the geometry before adding presentation details. It is easier to fix a simple outline than a drawing with dimensions and labels attached to an incorrect shape.
Save two useful copies
Open Export Manager and save a JSON copy for continued work in RLabCAD. Save a DXF copy if you plan to exchange the drawing with another CAD application.
Reopen one exported file and check the outline and circle. That final step confirms that you have a usable file outside browser storage. You now have a small, complete drawing workflow: construct, measure, export, and verify.